Calibration process for POP 1

@nitecap No you can’t , it’s only for POP2

You need to know a little bit about 3D modeling to better understand what to do in Revo Studio for best results , if you choice too higher value for meshing of an object that don’t need it , you will end with a lot of noises , and denoiser will only smooth out your modem even more.

usually for regular models without much elements the meshing value in Revo Scan will be 3-4 and 2 denoiser , if you scan an complex mesh like face you want to use the meshing value of 6 with 3-4 denoiser in Revo Scan . In Revo Studio things working differently and the meshing values are much greater than in Revo Scan … for example in Revo Scan meshing value # 6 is 25 % lower than meshing value 7 in Revo Studio.
And to be honest you can’t just learn the number , as it all depends of the objects you are scanning , not all objects needs the same values , so you need to practice , trial and error to create your own workflow .
I have some little tips in my thread if you like to check in .
My 3D Showcase models-tips

1 Like