After calibrating my Mini

[ivan]

After calibrating my Mini

It looks good Jeff , the second scan even better . The artifacts on the right branches are overlapped points . But nice sharpness overall, calibration at 0.0300+ or 0.0200+ do not make big difference in quality of the scan , more alignment of the RGB and better marker mode … the quality not getting affected unless it get above 0.0900

Calibration Issues & Tips

For those that going to calibrate MINI , you don’t need to put the scanning board on the angle , just angle the MINI focusing on the small dots as guide for the horizontal line until it appears green . Use some light on the side , not calibrate in dark light conditions, I used the Revopoint LED on this side . I calibrated using this software 3 devices, the results was 0.0235 what is the highest I ever got with fantastic scanning results and sharpness even on my Mini Beta device . But before …