My first scan and part build from it

[bigwookiee]

I need a switch panel for my rugged radio setup for my O.G. Can-Am Maverick. Here is the result of the scan by the Inspire.

[bigwookiee]

Here is the part in Fusion 360.

[PUTV]

Nice work @bigwookiee

Thanks for sharing David !

[Rilot]

Good job with that. If that’s your first scan, a very good effort indeed.

[bigwookiee]

Here is the completed part with it installed into the SxS. I went through a few iterations and had to reinforce the wing (not shown) that closes off the side of the compartment.

[Revopoint-Jane]

This is really very good scanning!