Revopoint MINI: merging MINI scan into a POP1 3D model

[dfodaro]

DONE!

Revopoint MINI - complete 3D scanning of 70 cm tall sculpture

Hello everyone, as promised I will post the result of the scan of a 72 cm tall sculpture, completely made with the MINI. I made a series of scans (0.02 resolution) which I then merged into Meshlab and meshed with CloudCompare. The model obtained rather large (over 4 million points) but the result satisfies me. As you can see the porous, eroded, wrinkled surface has been acquired by the scanner. The fine details of the surface modeling are recorded in the 3D model. Below is the result: [ros…