# Suggestion for Revoscan Software - Auto trimming edges **URL:** \ **Category:** Suggestions\ **Created:** [December 29, 2024, 10:44am UTC](https://forum.revopoint3d.com/t/suggestion-for-revoscan-software-auto-trimming-edges/31373 "2024-12-29T10:44:02Z")\ **Posts on this page:** 1\ **Showing post:** 2
**Author:** ![SphaeroX](https://avatars.discourse-cdn.com/v4/letter/s/5f8ce5/32.png) [@SphaeroX](https://forum.revopoint3d.com/u/SphaeroX)\ **Post date:** [December 29, 2024, 11:21am UTC](https://forum.revopoint3d.com/t/suggestion-for-revoscan-software-auto-trimming-edges/31373/2 "2024-12-29T11:21:15Z")
Don’t get your hopes up too much, I already criticized that a year ago 🙈 It’s a bug since RevoScan 5. > [@Clean Edge Selectiontool](https://forum.revopoint3d.com/t/clean-edge-selectiontool/23830): > > I noticed during scanning that when you scan an object from multiple sides, i.e., make several scans and then merge them at the end, it results in unclean transitions. You can see it here in the picture: So, I conducted a test and trimmed the outer edges in the individual scans. These were quite noisy because the light or the camera of the scanner is very weak there. The result is convincing! And I believe that if you always do this, even normal scans will benefit fro… --- _[View the full topic](https://forum.revopoint3d.com/t/suggestion-for-revoscan-software-auto-trimming-edges/31373)._